Siemens SICAM P 7KG7755 - Firmware Versions Overview

Firmware Versions
10
Power Meter, IEC 60870-5-103, Manual
E50417-B1076-C375-A4, Release 11.2012
1.1 Firmware Versions Overview
Firmware versions Two firmware versions V03 and V04 are available for the SICAM P 7KG7750/55
device which
• offer identical basic functionality,
• differ in the supported communication protocols (refer to Table 1-1),
• can be loaded alternatively in the SICAM P 7KG7750/55.
1)
Communication
protocols
Table 1-1 shows which communication protocols are supported by the SICAM P
7KG7750/55 firmware versions:
Table 1-1 Communication protocols vs. SICAM P 7KG7750/55 firmware versions
1)
PROFIBUS DP isn't available at devices SICAM P with the order no.
7KG7750-0xA0x-0AA1.
Firmware version
Communication protocol
PROFIBUS DP Modbus IEC 60870-5-103
V03 yes
1)
yes no
V04 no yes yes
Note:
For using the
IEC 60870-5-103 protocol a SICAM P 7KG7750/55 device with firmware
V04 is necessary
The use of the
IEC 60870-5-103 communication protocol and configuration software
“SICAM P Parameterization” up to V01.30 is limited to SICAM P 7KG7750/55 devices
with integrated display (7KG7750) because of additional communication parameters
(refer to chapter 1.2).