Operation and Display
4.3 Key Definition
SICAM P38 P39, 3-phase Power Meter with Multi-Tariff function, User Manual
E50417-H8940-C564-4, Release Date 06.2018
35
Note
For P39 device, the second communication port parameter setting can not be changed.
3. Parameter setting with keys (take "Conn communication setting" for example)
Figure 4-2 Parameter Setting with Keys
At any time, press " " and " " simultaneously to enter "PASS" screen. The first digit of displayed data
means password level and the remaining 6 data make up the password (press "▲" to change digits and "▼"
to move cursor). Press " " to confirm. "FAIL" will appear if password level and password are wrong. To re-
enter password, press " ". To quit and return to cyclic display state, enter " " (if specified error count is
reached, parameter setting function will be locked for certain period which is configurable in advance). If the
password is validated, you may enter the first-level menu. The figure shows the read-write items under "Conn"
menu: baud rate and communication address of RS485 port can be set.
Note
"SURE" screen appears after selecting or inputting parameter and pressing " ". Press " " once
again to activate new parameter. Pressing " " at any time during parameter setting will cancel setting or
return to previous menu.
■
To Next Page
Loading...
