Siemens Sicam P850 7KG85 Series - Page 117

7 Operation at Use of a PC
7.3 Configuration of the Device
117SICAM P850/P855, 7KG85xx, Device Manual
E50417-H1040-C482-A6, Edition 10.2018
7.3.1.3 Finish Configuration
When you have changed the configuration, you must either enable it as the active set of parameters or save it.
Activating the Set of Parameters
To activate the set of parameters, proceed as follows:
✧ In the navigation window, select the Finish configuration menu and click Activation.
Figure 7-19 Configure Tab, Activation Input/Output Window
✧ In the Activation input/output window, enter the valid activation password into the password field. Device
and Language explains how to set the activation password.
✧ Click Activation.
At first the message Parameter activation is still in progress will be shown and then the message
Parameter activation is complete in the input/output window.
The modified set of parameters is loaded as the active set of parameters into the device and the new
parameters take effect immediately.
If the password is wrong, this message appears: The password is wrong. Please enter the correct
password.
NOTE
The active and passive set of parameters are listed in the Activation input/output window in the Set column
for your information.