7 Operation at Use of a PC
7.3 Configuration of the Device
130 SICAM P850/P855, 7KG85xx, Device Manual
E50417-H1040-C482-A6, Edition 10.2018
7.3.3.1.3 LEDs
Default Settings and Setting Options of the LEDs
To change the outputs of the LEDs H1, H2, and ERROR, proceed as follows:
✧ In the navigation window, select the Operational menu, then the Process connections submenu and
click LEDs.
Figure 7-31 Configure Tab, LEDs Input/Output Window
Table 7-5 LED Settings
LED Default Setting Setting Options
RUN Device ready Not settable
ERROR -none- Errors are signaled as parameterized (only
error indications can be parameterized).
Acc. to list box
(see Operating Parameters)
H1 -none- Acc. to list box
(see Operating Parameters)
H2
Indication inverted no no
yes
To Next Page
Loading...
