7 Operation at Use of a PC
7.3 Configuration of the Device
131SICAM P850/P855, 7KG85xx, Device Manual
E50417-H1040-C482-A6, Edition 10.2018
✧ Select the desired parameters in the list boxes and option fields as described in Table 7-5.
✧ After the parameterization click Send.
The parameters are transmitted to the device but not enabled yet (passive set of parameters).
✧ If you do not want to make any additional settings, continue with the Activation of the device configuration
according to section Activating the Set of Parameters. If you want to change other settings, enter the
changes and then enable the device configuration as described in section Activating the Set of
Parameters.
Behavior of the LEDs
Figure 7-32 Behavior of the LEDs
NOTE
Select Indication -none- to disable the corresponding LED.
invalid
Indication
Indication
LED
invalid
L
H
ON
OFF
flash flash
To Next Page
Loading...
