7 Operation at Use of a PC
7.3 Configuration of the Device
154 SICAM P850/P855, 7KG85xx, Device Manual
E50417-H1040-C482-A6, Edition 10.2018
2)
According to EN 50160, up to 3 % unbalance can occur in 3-wire networks in areas with many 1-wire and
2-wire connections.
To change the report configuration, proceed as follows:
✧ In the navigation window of the Recording and Reporting menu click Report configuration.
Figure 7-46 Configure Tab, Report Configuration Input/Output Window (Excerpt)
✧ Use the buttons to select the evaluation mode or enter the user-defined mode into the fields according to
Tabl e 7- 17.
✧ After the parameterization click Send.
The parameters are transmitted to the device but not enabled yet (passive set of parameters).
✧ If you do not want to make any additional settings, continue with the Activation of the device configuration
according to section Activating the Set of Parameters. If you want to change other settings, enter the
NOTE
The factory settings are based on EN 50160. If you have changed the settings, the set parameters are applied
after a device restart. Resetting to the factory settings is possible.
To Next Page
Loading...
