7 Operation at Use of a PC
7.3 Configuration of the Device
172 SICAM P850/P855, 7KG85xx, Device Manual
E50417-H1040-C482-A6, Edition 10.2018
Serial Communication via the IEC 60870-5-103 Protocol
Figure 7-55 Configure Tab, Input/Output Window Communication Serial via IEC 60870-5-103
✧ Enter the desired values in the fields and select the parameters in the list box and in the option fields as
described in Table 7-23.
✧ After the parameterization click Send.
After clicking Send, the parameters are transmitted to the device but not enabled yet (passive set of
parameters).
✧ If you do not want to make any additional settings, continue with the Activation of the device configuration
according to section Activating the Set of Parameters. If you want to change other settings, enter the
changes and then enable the device configuration as described in section Activating the Set of
Parameters.
To Next Page
Loading...
