9 Operation at Use of a PC
9.2 Start and Design of the User Interface
139SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A6, Edition 06.2019
9.2 Start and Design of the User Interface
9.2.1 Initial Start of the Operation
Before starting the user interface, the following preconditions must be satisfied:
✧ Assemble the SICAM Q100 as described in chapter 7.2.
✧ Connect the lines for measurement, communication and supply voltage as described in chapter 7.3 and
observe the safety provisions.
✧ Switch on the devices needed for the measurement.
✧ Switch on the supply voltage of the SICAM Q100.
✧ Check whether the LEDs at the SICAM Q100 indicate that the device is ready (see chapter 13.2).
✧ Match the IP address and the subnet mask of the network interface card of your computer to the device
settings.
✧ Check on the computer screen whether the LAN connection is up. Activate the LAN connection if it is down
(see the Windows manual or the Windows online help for information).
✧ For checking purposes, carry out the ping test as follows (example for Windows):
Click Start on the Windows interface.
Select Execute....
Enter cmd in the dialog and click OK.
Enter: ping 192.168.0.55.
Press ENTER.
Check the following output in the window.
Figure 9-1 Ping Test
✧ Start the Web browser.
✧ Enter the IP address in the Web browser (for example default IP address: https://192.168.0.55) of
SICAM Q100 and press ENTER.
The user interface opens with the Information tab -> Show device information (see Figure 9-8).
MAN_SICAM_Q100_US.book Page 139 Wednesday, June 5, 2019 9:31 AM
To Next Page
Loading...
