9 Operation at Use of a PC
9.3 Configuration of the Device
157SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A6, Edition 06.2019
9.3.1.3 Finish Configuration
When you have changed the configuration, you must either enable it as the active set of parameters or save it.
Activating the Set of Parameters
To activate the set of parameters, proceed as follows:
✧ In the navigation window, select the Finish configuration menu and click Activation.
Figure 9-18 Configure Tab, Activation Input/Output Window
✧ Click Activation.
At first the message Parameter activation is still in progress will be shown and then the message
Parameter activation is complete in the input/output window.
The modified set of parameters is loaded as the active set of parameters into the device and the new
parameters take effect immediately.
Save Configuration to File
You can save both the active and the passive configuration to a file. Proceed as follows:
NOTE
The active and passive set of parameters are listed in the Activation input/output window in the Set column
for your information.
NOTE
During the parameter activation, the device is working under special mode. If one kind of recorders happens in
this duration, the integrity of the recorded data cannot be guaranteed.
MAN_SICAM_Q100_US.book Page 157 Wednesday, June 5, 2019 9:31 AM
To Next Page
Loading...
