9 Operation at Use of a PC
9.3 Configuration of the Device
189SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A6, Edition 06.2019
Figure 9-43 Configure Tab, Synchronization Source: Calendar, Fail with Gap or Overlap
✧ After the parameterization click Send.
The parameter is transmitted to the device but not enabled yet (passive parameter set).
✧ If you do not want to make any additional settings, continue with the Activation of the device configuration
according to section Activating the Set of Parameters. If you want to change other settings, enter the
changes and then enable the device configuration as described in section Activating the Set of
Parameters.
NOTE
If you change the setting value of the parameter Synchronization source from Protocol to Binary input, you
must reselect the tariff. Otherwise, the value will be cumulated in the previous tariff.
MAN_SICAM_Q100_US.book Page 189 Wednesday, June 5, 2019 9:31 AM
To Next Page
Loading...
