9 Operation at Use of a PC
9.3 Configuration of the Device
214 SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A6, Edition 06.2019
Parameterizing the Time Synchronization
To change the time synchronization, proceed as follows:
✧ In the navigation window, select the Administrative menu and click Time synchronization.
Figure 9-56 Configure Tab, Time Synchronization Input/Output Window, Ethernet NTP Selected
✧ Enter the desired values in the fields and select the parameters in the list boxes and in the option field as
described in Table 9-23.
✧ After the parameterization click Send.
The parameters are transmitted to the device but not enabled yet (passive set of parameters).
✧ If you do not want to make any additional settings, continue with the Activation of the device configuration
according to section Activating the Set of Parameters. If you want to change other settings, enter the
changes and then enable the device configuration as described in section Activating the Set of
Parameters.
Secondary NTP server IP address 192.168.0.253 Any
No polling of the NTP server if
0.0.0.0 was entered
Error indication after 10 min 2 min to 120 min
Additional Parameter if the Source is Fieldbus (Modbus RTU and IEC 60870-5-103)
Error indication after 10 min 2 min to 120 min
Table 9-23 Time Synchronization Settings (cont.)
Parameter Default Setting Setting Range
MAN_SICAM_Q100_US.book Page 214 Wednesday, June 5, 2019 9:31 AM
To Next Page
Loading...
