9 Operation at Use of a PC
9.3 Configuration of the Device
218 SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A6, Edition 06.2019
Settings Protocol Modbus
✧ Enter the desired values in the fields and select the parameters in the list boxes and in the option field as
described in Table 9-24.
Figure 9-58 Protocol Modbus
Settings Modbus TCP/RTU Gateway
To a c ti v e Modbus TCP/RTU Gateway, proceed as follows:
✧ Select yes in Administrative -> Communication Ethernet -> Modbus TCP/RTU Gateway ->
Activated.
Figure 9-59 Modbus TCP/RTU Gateway
✧ Enter the desired values into the fields (acc. to Table 9-24).
✧ After the parameterization click Send.
After clicking Send, the parameters are transmitted to the device but not enabled yet (passive set of
NOTE
If you have selected no under Use a user-port number, you can adjust only the Access rights for user
port 502, the Keep Alive time and the Communication supervision time parameters.
NOTE
The Modbus TCP/RTU Gateway function requires that the Modbus RTU Master has been selected as serial
protocol in addition; see chapter 9.3.7.3.
MAN_SICAM_Q100_US.book Page 218 Wednesday, June 5, 2019 9:31 AM
To Next Page
Loading...
