9 Operation at Use of a PC
9.3 Configuration of the Device
220 SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A6, Edition 06.2019
9.3.7.2.2 Parameterizing the Ethernet Communication with IEC 61850 Bus Protocol
✧ In the Bus protocol list box select the entry IEC 61850.
The Communication Ethernet input/output window with Protocol IEC 61850 opens.
Figure 9-61 Configure Tab, Communication Ethernet via IEC 61850 Input/Output Window
✧ Enter the desired values into the fields and select the parameter in the list boxes as described in
Table 9-24.
✧ If several SICAM Q100 devices are used in the substation, change the name of the SICAM Q100 (factory
setting SICAM_Q100_01) in the IED Name field.
The name must be identical to the name which has been parameterized for this SICAM Q100 in the
configurator of the substation.
✧ After the parameterization click Send.
After clicking Send, the parameters are transmitted to the device but not enabled yet (passive set of
parameters).
MAN_SICAM_Q100_US.book Page 220 Wednesday, June 5, 2019 9:31 AM
To Next Page
Loading...
