9 Operation at Use of a PC
9.3 Configuration of the Device
264 SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A6, Edition 06.2019
Parameterizing the Syslog
To change the settings of the Syslog, proceed as follows:
✧ In the navigation window, select the Administrative menu and click Syslog.
Figure 9-83 Configure Tab, Syslog Input/Output Window
✧ In the Parameter fields, enter the desired values according to Table 9-42.
✧ After the parameterization click Send.
After clicking Send, the parameters are transmitted to the device but not enabled yet (passive set of
parameters).
✧ If you do not want to make any additional settings, continue with the Activation of the device configuration
according to section Activating the Set of Parameters. If you want to change other settings, enter the
changes and then enable the device configuration as described in section Activating the Set of
Parameters.
MAN_SICAM_Q100_US.book Page 264 Wednesday, June 5, 2019 9:31 AM
To Next Page
Loading...
