9 Operation at Use of a PC
9.5 Maintenance
316 SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A6, Edition 06.2019
The following table shows examples of events logged in the audit log.
Table 9-50 Audit-Log Events in SICAM Q100
Event Type Description
Modification of security-relevant
parameterization
Modify following settings:
• IP address
• Modbus TCP access rights for port 502
• Modbus TCP access rights for user port
• Modbus RTU access rights
• Device name
Firmware update Upload new firmware to the device
Logon succeeded The correct user name and password are entered.
Logon failed Incorrect user name and password have been entered for the
times configured by the maximum consecutive attempts in the
chapter 6.3.2.
Value forcing Delete or reset the following data:
• Operational log, error log, and transient log
• Min/max values
• Load profile
• Energy counters
• Events like voltage event, frequency event, voltage-
unbalance event, MSV event, RVC event
Configuration access Upload a configuration file or start configuration
Configuration change Change the configuration
Audit log access Access the audit log
Time/date change Change the time or the date
Device reboot Device is rebooted due to:
• Firmware upload
• SD-card formatting
• IP-address change
• Default-gateway change
• Subnet-mask change
• Default IP setting change
• User-language change
• Network-type change
• IED-name change
• IEC 61850 enable
• Power-quality values for PN and PP setting change
• Voltage RMS value PN and PP setting change
SD card plugged Plug in an SD card
SD card unplugged Unplug the SD card
Default IP set Request the default IP address by pressing key F4 on the
device display for 5 s
MAN_SICAM_Q100_US.book Page 316 Wednesday, June 5, 2019 9:31 AM
To Next Page
Loading...
