Siemens SICAM Q100 7KG95 Series - Flowchart of Modbus RTU Master and Modbus Gateway Parameterization

9 Operation at Use of a PC
9.8 Flowchart of Modbus RTU Master and Modbus Gateway Parameterization
335SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A6, Edition 06.2019
9.8 Flowchart of Modbus RTU Master and Modbus Gateway
Parameterization
Figure 9-151 Flowchart of Modbus RTU Master and Modbus Gateway Parameterization
Start
Configure serial communication and select bus
protocol "Modbus RTU Master"
User interface:
Configure: Communication serial (chapt. 8.3.7.3)
Configure Modbus slave device
User interface:
Configure: Modbus slavedevices (chapt. 8.3.7.4)
Configure data mapping for the Modbus slave device
User interface:
Configure: Mapping - Measured values (chapt. 8.3.7.4.2)
Configure: Mapping - Indications (chapt. 8.3.7.4.3)
Export already configured Modbus slave
device with mapping information as file
User interface:
Configure: Mapping - Export (chapt. 8.3.7.4.4)
Import a saved Modbus slave device
configuration with mapping information
User interface:
Configure: Mapping - Import (chapt. 8.3.7.4.5)
Configure Ethernet communication and select bus
protocol "Modbus TCP"
User interface:
Configure: Communication Ethernet(chapt. 8.3.7.2)
Configure Modbus Gateway settings
User interface:
Configure: Communication Ethernet(chapt. 8.3.7.2.1)
Final
[Gateway function
required?]
[Only Modbus RTU Master required]
[Another Modbus slave device and different
device type than configured before?]
[Another Modbus slave device from
same type than configured before?]
[Also Modbus RTU
Master required]
[No more Modbus slave
devices to configure ]
MAN_SICAM_Q100_US.book Page 335 Wednesday, June 5, 2019 9:31 AM