13 Failures and LED Indications
13.1 General Inspection
368 SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A6, Edition 06.2019
13.1 General Inspection
Visual Inspection
If function failures occur, first check the device visually. Observe the following points when inspecting the device
visually:
• Correct installation of the device as described in chapter 7.2 at the intended location
• Compliance with the environmental conditions specified in chapter 14.1.4 of the technical data
• Correct connection of supply voltage and grounding conductors according to chapter 7.3
• Correct connection of measuring and communication lines according to chapter 7.7.1
Function Checks
Additionally, check the following aspects:
• Functioning of the display according to chapter 10.2 and good visibility of the display
• Correct functioning of peripheral devices (e.g. connected PC, series-connected current transformers)
• Compliance with the system requirements specified in chapter 7.4
• Compliance with the access rights according to chapter 7.5
• Compliance with the commissioning sequence of the device according to chapter 7.7
• Evaluation of the LED failure indications, see chapter 13.2
MAN_SICAM_Q100_US.book Page 368 Wednesday, June 5, 2019 9:31 AM
To Next Page
Loading...
