Siemens SICAM Q100 7KG95 Series - Page 371

13 Failures and LED Indications
13.2 Indications Signaled by LEDs
371SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A6, Edition 06.2019
Table 13-1 Indications Signaled by LEDs on the Top Side of the Housing
LED Meaning
No Operation
Device is switched off.
Device is switched on, but firmware is not loaded.
or
Device is in startup phase.
Normal Operation
Configured IP address is used.
or
IP address is received via DHCP.
H1 and H2 LEDs are configured.
Normal operation with default IP address
The default IP address was requested by pressing the F4 softkey during
normal operation.
Double IP address has been detected in the network.
The device is in operation but cannot be reached via Ethernet.
Solve this network configuration issue and restart the device.
Each device must have a unique IP address.
An IP address request via DHCP is in progress.
ERROR = off, H1 and H2 LEDs according to configuration
RUN LED stops flashing when IP address is received.
The device runs into the Fallback mode after an unresolvable error in normal
operation occurs or by pressing the F4 softkey during device startup.
RUN ERROR
H1 H2
RUN ERROR
H1 H2
RUN ERROR
H1 H2
C C
RUN ERROR
H1 H2
C
C
ERRORRUN
H1 H2
C C
ERROR
ERRORRUN
H1 H2
C C
ERROR
MAN_SICAM_Q100_US.book Page 371 Wednesday, June 5, 2019 9:31 AM