13 Failures and LED Indications
13.3 Troubleshooting, Repair, and Fallback Mode
378 SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A6, Edition 06.2019
Figure 13-6 Fallback Mode, Firmware
Firmware upload
This session is available for the user with a role of installer or administrator. You can find more information on
uploading the firmware in chapter 9.5.1 Firmware Upload.
Save information
In this section, you can click Save device information to save the device-specific information to a local file. It
is available for the user with a role of viewer, operator, installer, engineer, backup operator, or administrator.
Parameter reset
In this section, you can restart the device with the default parameter set. It is available for the user with a role
of engineer, installer, or administrator.
Error log
In this section, you can delete the error messages in the error-log file. It is available for the user with a role of
operator or administrator.
NOTE
The section Run calibration is a service function. This function is exclusively used at the factory.
MAN_SICAM_Q100_US.book Page 378 Wednesday, June 5, 2019 9:31 AM
To Next Page
Loading...
