EasyManua.ls Logo

Siemens SICAM Q100 7KG95 Series - Communication Interfaces

Siemens SICAM Q100 7KG95 Series
448 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
14 Technical Data
14.1 General Device Data
383SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A6, Edition 06.2019
14.1.3 Communication Interfaces
Ethernet (Connector Z)
Serial Interface (Connector J)
Ethernet, electrical
Connection Device top side
RJ45 connector socket
10/100Base-T acc. to IEEE802.3
LED yellow: 100 Mbit/s (off/on)
LED green:
flashing: active
on: not active
off: no connection
Protocols Modbus TCP
IEC 61850 Server
Voltage strength DC 700 V, AC 1500 V
Transmission rate 100 Mbit/s
Cable for 10/100 Base-T 100 to 150 STP, CAT5
Maximum cable length
10/100 Base-T
100 m, if well installed
RS485 Connection Terminal side, 9-pin D-sub socket
Protocol Modbus RTU Master and gateway function
Baud rate (adjustable) Min. 1200 bit/s
Max. 115 200 bit/s
Maximum distance of
transmission
Max. 1 km
(depending on transmission rate)
Transmission level Low: -5 V to -1.5 V
High: +1.5 V to +5 V
Reception level Low: -0.2 V
High: +0.2 V
Bus termination Not integrated, bus termination using plugs with
integrated bus terminating resistors (see figure
14-1 )
MAN_SICAM_Q100_US.book Page 383 Wednesday, June 5, 2019 9:31 AM

Table of Contents

Related product manuals