16 Operating Parameters
16.6 Administrative
421SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A6, Edition 06.2019
16.6.2 Ethernet Communication
Parameter Default Setting Setting Range
Communication Ethernet
IP address
1)
192.168.0.55 Any
0.0.0.0 = DHCP
Subnet mask
1)
255.255.255.0 Any
Default gateway
1)
192.168.0.1 Any
Ethernet switch on no no
yes
Enable SNMP no no
yes
OPC UA PubSub (MQTT) no no
yes
Bus protocol Modbus TCP -none-
Modbus TCP
IEC 61850
Both
Protocol Modbus TCP
Use a user-port number
2)
no no
yes
User-port number
2)
(can only be set when Use a user-port
number is parameterized with yes)
10 000 10 000 to 65 535
Access rights for user port
(can only be set when Use a user-port
number is parameterized with yes)
Full Full
Read only
Access rights for port 502 Full Full
Read only
Keep Alive time 10 s 0 s = switch off
1 s to 65 535 s
Communication supervision time 600 (* 100 ms) 0 s = none
100 ms to 6 553 400 ms
Modbus TCP/RTU Gateway
(Condition: The Modbus RTU Master protocol must have been selected under serial communication.)
Activated no no
yes
MAN_SICAM_Q100_US.book Page 421 Wednesday, June 5, 2019 9:31 AM
To Next Page
Loading...
