Siemens SICAM Q100 7KG95 Series - Communication Serial

16 Operating Parameters
16.6 Administrative
424 SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A6, Edition 06.2019
16.6.4 Communication Serial
Parameter Default Setting Setting Range
Bus protocol Modbus RTU -none-
Modbus RTU
Modbus RTU Master
Bus Protocol Modbus RTU (Slave)
Device address 1 1 to 247
Baud rate 19 200 bit/s 1200 bit/s, 2400 bit/s
4800 bit/s, 9600 bit/s
19 200 bit/s, 38 400 bit/s
57 600 bit/s, 115 200 bit/s
Parity Even None, 1 stop bit
Even
Odd
None, 2 stop bit
Access rights Full Full
Read only
Communication supervision time 600 * 100 ms 0 s = none
100 ms to 6 553 400 ms
Bus Protocol Modbus RTU Master
Baud rate 19 200 bit/s 1200 bit/s, 2400 bit/s
4800 bit/s, 9600 bit/s
19 200 bit/s, 38 400 bit/s
57 600 bit/s, 115 200 bit/s
Parity Even None, 1 stop bit
Even
Odd
None, 2 stop bit
MAN_SICAM_Q100_US.book Page 424 Wednesday, June 5, 2019 9:31 AM