Siemens SICAM Q100 - Setting the Operational Parameters

8 Operation at Use of a PC
8.3 Configuration of the Device
139SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A4, Edition 03.2018
8.3.3 Setting the Operational Parameters
In the Configure tab you can view and edit the set operational parameters. You can select the parameters in
the Operational menu in the navigation window. The submenus Process connections, Select automation
function, HMI, PQ Management and Administrative are available for making the settings. The submenus
contain the following elements:
• Process connections
 AC measurement
 Binary inputs
 Binary outputs
 LEDs
• Select automation functions
 Limits 1-8
 Limits 9-16
 Group indications 1-4
NOTE
Observe the procedure for the device configuration described in chapter 8.3.1 when you set the operational
parameters.
NOTE
If you change the Network type during ongoing operation, check the settings, measured values, and limiting
values for inconsistencies. Check also the ICD file which is suitable for the network type. If there are any invalid
measured values and limiting values or a wrong ICD file, restart the device.