8 Operation at Use of a PC
8.3 Configuration of the Device
150 SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A4, Edition 03.2018
8.3.3.1.4 LEDs
Default Settings and Setting Options of the LEDs
Parameterization of the LEDs
To change the outputs of the LEDs H1, H2, and ERROR, proceed as follows:
✧ In the navigation window, select the Operational parameters menu, then the Process connections
submenu and click LEDs.
Figure 8-32 Configure Tab, LEDs Input/Output Window
Table 8-5 LED Settings
LED Default Setting Setting Options
RUN Device ready Not settable
H1 -none- Acc. to list box
(see chapter 15)
H2
ERROR -none- Errors are signaled as parameterized (only
error indications can be parameterized).
Acc. to list box
(see chapter 15)
Indication inverted no no
yes
To Next Page
Loading...
