Siemens SICAM Q100 - Page 153

8 Operation at Use of a PC
8.3 Configuration of the Device
153SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A4, Edition 03.2018
Parameterizing a Limit
To change, for example, limit 1, proceed as follows:
✧ In the navigation window, select the Operational parameters menu, then the Select automation
functions submenu and click Limits 1-8.
Figure 8-34 Configure Tab, Limits 1-8 Input/Output Window (Detail)
✧ Enter the desired values in the fields and select the parameters in the list boxes and option fields as
described in Table 8-6.
Hysteresis of the Limit Value Violation
Figure 8-35 Hysteresis (General Representation)
t
100 %
0 %
Start StartEnd End
Permissible
range
Limit Min
Limit Max
Hysteresis range
NOTE
Select Measurement -none- to disable the corresponding limit indication.