Siemens SICAM Q100 - Page 159

8 Operation at Use of a PC
8.3 Configuration of the Device
159SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A4, Edition 03.2018
8.3.4.2 User-Defined Screens
In the User-defined screen menu you can parameterize up to 4 different User screens. Each Screen type
allows you to select whether to display the measured values numerically (2 or 4 measured values) or
graphically and numerically (2 or 3 measured values). To select which of the 4 screens is presently displayed
on the device, you must
use the device softkeys and the HTML page.
Default Settings and Setting Ranges
1)
If you have not made any selection, the displays explained in the following do not exist.
Table 8-9 Settings of User Screens
Parameter Default Setting Setting Range
Screen type -none-
1)
-none-
2 measured values, numerical
4 measured values, numerical
2 measured values, graphical + numerical
3 measured values, graphical + numerical
Screen name USER_SCREEN_x
(x = 1 to 4)
Max. 18 characters
Only English and German letters,
numbers, and special characters are
permitted.
2 measured values, numerical
Display 1, numerical
Display 2, numerical
-none- Acc. to list box
(see chapter 15)
4 measured values, numerical
Display 1, numerical
Display 2, numerical
Display 3, numerical
Display 4, numerical
-none- Acc. to list box
(see chapter 15)
2 measured values, graphical
and numerical
Display 1, graph./num.
Display 2, graph./num.
-none- Acc. to list box
(see chapter 15)
3 measured values, graphical
and numerical
Display 1, graph./num.
Display 2, graph./num.
Display 3, graph./num.
-none- Acc. to list box
(see chapter 15)
Display x, graph./num.
(x = 1 to 3)
Min value
Max value
1.0
10.0
(unit according to
measured value)
The minimum and maximum value are
defined by the selected parameters (see
chapter 8.3.3.1.1).