8 Operation at Use of a PC
8.3 Configuration of the Device
181SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A4, Edition 03.2018
Changing the Report Configuration
To change the report configuration, proceed as follows:
✧ In the navigation window of the Recording and Reporting menu click Report configuration.
Figure 8-50 Configure Tab, Report Configuration Input/Output Window (Excerpt)
✧ Use the buttons to select the evaluation mode or enter the user-defined mode into the fields according to
Table 8-18.
✧ After the parameterization click Send.
The parameters are transmitted to the device but not enabled yet (passive set of parameters).
✧ If you do not want to make any additional settings, continue with the Activation of the device configuration
according to section Activating the Set of Parameters. If you want to change other settings, enter the
changes and then enable the device configuration as described in section Activating the Set of
Parameters.
NOTE
The chapter 8.4.2.4 describes the output of the power quality report.
To Next Page
Loading...
