8 Operation at Use of a PC
8.3 Configuration of the Device
182 SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A4, Edition 03.2018
8.3.6.7 Recording Parameters and Power Quality Data
Default Settings and Setting Ranges
Changing the Recording Parameters
To change the recording parameter settings, proceed as follows:
✧ In the navigation window of the Recording and Reporting menu click Recorders - Start/Stop.
Figure 8-51 Configure Tab, Recording Parameters Input/Output Window
✧ Select the parameter in the list box according to Table 8-19.
✧ After the parameterization click Send.
The parameters are transmitted to the device but not enabled yet (passive set of parameters).
✧ If you do not want to make any additional settings, continue with the Activation of the device configuration
according to section Activating the Set of Parameters. If you want to change other settings, enter the
changes and then enable the device configuration as described in section Activating the Set of
Parameters.
Depending on the parameterized Start record option, the Start time field shows the start time of the recording.
After activation, the recording starts automatically at the specified time. If the Start immediately option is
selected, the recording also only starts after activation.
After recording has started, the Recording status fields shows the entry Running.
Table 8-19 Reporting Parameters
Parameter Default Setting Setting Range
Start record option Start next 10th minute Start next minute
Start next 10th minute
Start immediately
Start next hour
Start next day
Start time - Display of the start time according to the settings
of the Date/time format, see chapter 8.3.7.6.
Recording status - Not settable
Recorder status display started or recorder
stopped
To Next Page
Loading...
