8 Operation at Use of a PC
8.3 Configuration of the Device
189SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A4, Edition 03.2018
8.3.7.2.1 Parameterizing the Ethernet Communication with Modbus TCP Bus Protocol
General Settings Communication Ethernet
To change the Ethernet communication settings, proceed as follows:
✧ In the navigation window, click the Administrative menu and then the element Communication
Ethernet. Select the bus protocol Modbus TCP.
Figure 8-54 Configure Tab, Communication Ethernet via Modbus TCP Input/Output Window
✧ Enter the desired values in the fields and select the parameters in the list boxes and in the option field as
described in Table 8-22.
NOTE
The enabling of SNMP via option Enable SNMP is only required if you want to save the SICAM Q.mib file and
use it in a MIB browser. See also section Download SNMP Device MIB File.
NOTE
After changing the network settings and subsequent parameter activation the device will reset.
To Next Page
Loading...
