8 Operation at Use of a PC
8.3 Configuration of the Device
191SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A4, Edition 03.2018
✧ If you do not want to make any additional settings, continue with the Activation of the device configuration
according to section Activating the Set of Parameters. If you want to change other settings, enter the
changes and then enable the device configuration as described in section Activating the Set of
Parameters.
Download SNMP Device MIB File
✧ Select yes in the Enable SNMP option (see figure 8-54).
✧ In the Communication Ethernet input/output window, click Download SNMP device MIB file.
Figure 8-57 File Download Dialog Box
✧ Click Save.
The Save As dialog opens (see figure 8-12) and you can save the SICAM Q.mib file in any folder and use
it in a MIB browser.
✧ After the parameterization click Send.
After clicking Send, the parameters are transmitted to the device but not enabled yet (passive set of
parameters).
✧ If you do not want to make any additional settings, continue with the Activation of the device configuration
according to section Activating the Set of Parameters. If you want to change other settings, enter the
changes and then enable the device configuration as described in section Activating the Set of
Parameters.
NOTE
The SNMP protocol is implemented in SICAM Q100 in order to be able to retrieve manufacturer-specific
information.
To retrieve information via SNMP, a MIB browser and the SICAM Q.mib file are required. The MIB browser
allows the displaying of SNMP information objects and their content.
To Next Page
Loading...
