8 Operation at Use of a PC
8.3 Configuration of the Device
194 SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A4, Edition 03.2018
8.3.7.3 Communication Serial via RS485 Interface
Default Settings and Setting Ranges of the Communication Serial
Table 8-23 Communication Serial Settings
Parameter Default Setting Setting Range
Bus protocol Modbus RTU -none-
Modbus RTU
Modbus RTU Master
Bus Protocol Modbus RTU (Slave)
Device address 1 1 to 247
Baud rate 19 200 bit/s Acc. to list box
(see chapter 15)
Parity Even Acc. to list box
(see chapter 15)
Access rights Full Full
Read only
Communication supervision time 600 * 100 ms 0 s = none
100 ms to 6 553 400 ms
Bus Protocol Modbus RTU Master
Baud rate 19 200 bit/s Acc. to list box
(see chapter 15)
Parity Even Acc. to list box
(see chapter 15)
To Next Page
Loading...
