8 Operation at Use of a PC
8.3 Configuration of the Device
196 SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A4, Edition 03.2018
Parameterizing the Serial Communication with Modbus RTU (Slave) or Modbus RTU Master
To change the serial communication settings, proceed as follows:
✧ In the navigation window, select the Administratives menu and click Communication serial.
The Communication serial input/output window opens.
✧ In the list box select Bus protocol.
If you select -none-, no protocol will be available. Click Send in this case.
Figure 8-59 Configure Tab, Communication Serial via Modbus RTU Master Input/Output Window
✧ Enter the desired values into the fields and select the corresponding parameters in the list boxes as
described in Table 8-23.
✧ After the parameterization click Send.
After clicking Send, the parameters are transmitted to the device but not enabled yet (passive set of
parameters).
✧ If you do not want to make any additional settings, continue with the Activation of the device configuration
according to section Activating the Set of Parameters. If you want to change other settings, enter the
changes and then enable the device configuration as described in section Activating the Set of
Parameters.
To Next Page
Loading...
