8 Operation at Use of a PC
8.3 Configuration of the Device
220 SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A4, Edition 03.2018
To change the settings of device and language, proceed as follows:
✧ In the navigation window, select the Administrative menu and click Device and language.
Figure 8-72 Configure Tab, Device and Language Input/Output Window
✧ Select the desired parameters in the list box according to Table 8-33.
✧ Change the passwords if necessary.
✧ If necessary, change the user language (see below).
✧ After the parameterization click Send.
After clicking Send, the parameters are transmitted to the device but not enabled yet (passive set of
parameters).
✧ If you do not want to make any additional settings, continue with the Activation of the device configuration
according to section Activating the Set of Parameters. If you want to change other settings, enter the
changes and then enable the device configuration as described in section Activating the Set of
Parameters.
Changing the User Language Preselection
The user language can be preset, for example when starting the User Interface for the first time (see
chapter 8.2.1). DEUTSCH is set by default.
To Next Page
Loading...
