8 Operation at Use of a PC
8.4 Value View and Evaluation
223SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A4, Edition 03.2018
Depending on which operational parameters are selected, the input/output window displays the measured
values with the corresponding unit or indications in a tabular list that is updated every 5 s.Harmonics and
interharmonics can represent you in tabular form or graphically.
To print out the value, click the (Print) icon on the toolbar of Microsoft Internet Explorer.
8.4.1.1 Evaluation of Harmonic Voltage, Current, and Power
The values for harmonics are displayed in the Value view and evaluation tab. If you want to display the values
on the screen, proceed as follows:
In the Value view and evaluation tab, click Operational parameters Process connections Harmonic
voltage or Harmonic current or Harmonic Power.
Figure 8-74 Example for a Table of Voltage Harmonics
The parameter Hide Harmonic when magnitude is lower than % is displayed above the measurement table.
This parameter indicates from which RMS value of the voltage, of the current or from which amount of power
on the display of the harmonic shall be hidden. This threshold value is active if you press the ENTER key. It is
NOTE
If symbol *** is displayed instead of a value, this value is invalid.
If symbol ^^^ is displayed instead of a value, this value is in overflow.
To Next Page
Loading...
