8 Operation at Use of a PC
8.4 Value View and Evaluation
235SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A4, Edition 03.2018
✧ Select from the Measurement output list box whether the measured values are to be output as a Table
or a CSV file is to be created.
Measurement Output as Table
✧ Click Display.
The determined results are displayed in a table. In multi-paged tables you can navigate forward and back
in the pages using the >> and << buttons. If you want to view a certain page, enter the page at the bottom
and click on show.
The results can be displayed graphically using COMTRADE viewer (link in Diagram column).
Measurement Output as CSV File
✧ Click Download.
The File Download dialog opens.
Figure 8-85 Dialog File Download
File Download -> Save CSV File
✧ Click Save.
The Save As dialog opens.
✧ Select the file path in the Save in: list box.
NOTE
In the find result list, Related phase only displays the current trigger phases of the selected event detection
mode, but Diagram will display the voltage information of all the phases that meet the trigger condition.
When an event has occurred, with this setting the recordings are marked in red on the record list under Find
result list. And a message is showed under the list when event happen. For information about the flagging con-
cept, please refer to chapter 4.1.1.
To Next Page
Loading...
