Siemens SICAM Q100 - Page 268

8 Operation at Use of a PC
8.7 Example of a Parameterization and Measured Value Evaluation
268 SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A4, Edition 03.2018
Features of the SICAM Q100
• 4 inputs for alternating current measurements
• 4 inputs for alternating voltage measurements
• 2 binary inputs
• 2 binary outputs
• Standard interface: Ethernet with Modbus TCP protocol
• Serial interface: RS485 with Modbus RTU protocol
• 4 LEDs for displaying operating states
• Recorder
Connection Diagram
Figure 8-114 Connection Diagram
Device Terminals Used for Measurements and Communication
Figure 8-115 Terminals and Interfaces Used at the Device
a
b
P1 P2
S1 S2
c
P1
S1 S2 S1 S2
N
P1
P2
P2
AAA
BBB
aaa
bbb
PE
je 10 A
Binary inputs
Voltage measuring
inputs
Supply
voltage
Ethernet connection
via RJ45 on the
device top side
RS485
interface
Current
Binary outputs
measuring
inputs