3 Device Design
3.2 Display and Softkeys
27SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A4, Edition 03.2018
3.2 Display and Softkeys
Display
The layout of the display is shown in the following figure.
Figure 3-2 Display and Softkeys
The top line (title) shows the name of the current display in the display area.
The display area below shows parameter settings, measured values, and graphic pictures.
The bottom line shows the 4 current functions of the softkeys below the display used to set the parameters.
Softkeys
The 4 softkeys on the display side are used to make the desired entries at the device.
To call and activate the IP address, press softkey F4 (for > 3 s, see Figure 3-2) on the right during system
startup if necessary. The IP address and the standard subnet mask are imprinted on the side panel of the device
(see Figure 3-1).
Chapter 9 gives a detailed description of the softkey functions.
Title
Display area
Softkey functions
Softkeys F1 to F4
To Next Page
Loading...
