Siemens SICAM Q100 - Page 290

9 Operation at Use of the Display
9.4 Parameterization
290 SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A4, Edition 03.2018
Submenu Display Number 32.4: Load Profile
Figure 9-21 Submenu Display Number 32.4, Load Profile
NOTE
If you select the Load profile parameter, this note is displayed first:
Changing these parameters reset the load profile!
To confirm, press the softkey F4 (Ok).
Table 9-4 Load Profile Settings
Parameter Default Setting Setting Range
Subperiod 15 min 1 min to 6 min in 1-min steps, 10 min, 12 min,
15 min, 20 min, 30 min, 60 min
Subperiods 1 1 to 5
Sync.source Interne Uhr None
Protocol
BinIn1 (binary input1)
BinIn2 (binary input 2)
Int. clock
Reactive power Q1 Q1
Qn
Qtot
32.4
Load profile
32.4
Subperiod
Enter
32.4
Subperiods
Edit
+
-
Edit
32.4
Sync.source
Edit


Select. parameters acc .
to following table
Ok
32.4
Reactive power
Edit
Esc