Siemens SICAM Q100 - Page 292

9 Operation at Use of the Display
9.4 Parameterization
292 SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A4, Edition 03.2018
Submenu Display Number 32.6: Communication
Figure 9-23 Submenu Display Number 32.6, Communication
32.6
Communication
39.0
IP Address
Enter
Edit
39.1
Communication
Ethernet


Enter
39.0
MAC addr.
IP addr.
Subnet
Gateway
+
Enter
39.1
Bus protocol:
- Modbus TCP
- IEC61850
39.2
Communication
Serial
EditEnter
39.2
Bus protocol:
- Modbus RTU
- Modbus Master
-None


Edit
Select. parameters
acc. to following table
Ok
Esc
Working on
choice


Edit
Ok
Esc
Change the para -
meters acc. to
following table
Ok
Esc
+
-

39.13
Modbus TCP/
RTU gateway
Enter
39.13
Activated
Not activated
NOTE
The MAC address is shown on the display but cannot be edited.
For this purpose, a prompt is displayed which you must acknowledge with Ok.