9 Operation at Use of the Display
9.4 Parameterization
298 SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A4, Edition 03.2018
Password Protection
If you have selected the option Use password = no on the HTML page (see Chapter 8.3.4.1), you can use the
softkeys to parameterize the device without entering a password.
If you have selected the option Use password = yes on the HTML page (see Chapter 8.3.4.1), you must first
enter the activation password (default setting 000000) before you can edit the device settings. A prompt is
displayed for this purpose.
After you have entered the correct password, you can edit the parameterization using the softkeys within the
next 15 minutes. After this time you have to re-enter the password at the device.
State ON ON
OFF (O)
acc. to current configuration
Reset
Clear min/max values - Yes (checkmark)
No
Reset counters - Yes (checkmark)
No
Execute...
(prompt whether selected function is
executed)
- Confirm with Enter
Table 9-11 Advanced Settings (cont.)
To Next Page
Loading...
