12 Failures and LED Indications
12.1 General Inspection
308 SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A4, Edition 03.2018
12.1 General Inspection
Visual Inspection
If function failures occur, first check the device visually. Observe the following points when inspecting the device
visually:
• Correct installation of the device as described in Chapter 6.2 at the intended location
• Compliance with the environmental conditions specified in Chapter 13.1.4 of the technical data
• Correct connection of supply voltage and grounding conductors according to Chapter 6.3
• Correct connection of measuring and communication lines according to Chapter 6.7.1
Function Checks
Additionally, check the following aspects:
• Functioning of the display according to Chapter 9.2 and good visibility of the display
• Correct functioning of peripheral devices (e.g. connected PC, series-connected current transformers)
• Compliance with the system requirements specified in Chapter 6.4
• Compliance with the access rights according to Chapter 6.5
• Compliance with the commissioning sequence of the device according to Chapter 6.7
• Evaluation of the LED failure indications, see Chapter 12.3.
To Next Page
Loading...
