Siemens SICAM Q100 - Page 314

12 Failures and LED Indications
12.3 Indications Signaled by LEDs
314 SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A4, Edition 03.2018
The boot program is started after the F4 softkey was pressed (calling the
default IP address) during startup when switching on the supply voltage.
The IP address was configured or received from DHCP.
DHCP active (H1 switches off after receiving the IP address via
DHCP)
The default IP address was confirmed by pressing the F4 softkey.
Boot loader started; no process application exists
The IP address was configured or received from DHCP.
DHCP active (LED H1 switches off after receiving the IP address via
DHCP)
The default IP address was confirmed by pressing the F4 softkey.
Table 12-1 Indications Signaled by LEDs on the Top Side of the Housing (cont.)
LED Meaning
RUN ERROR
H1 H2
RUN ERROR
H1 H2
RUN ERROR
H1 H2
RUN ERROR
H1 H2
RUN ERROR
H1 H2
RUN ERROR
H1 H2