15 Operating Parameters
15.2 Automation Functions
346 SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A4, Edition 03.2018
15.2.2 Group Indications 1-4
1)
31 bytes of UTF-8
Parameter Default Setting Setting Range
Source
NOTES
Only the indications for the
parameterization of the
binary outputs are displayed
which can be used accord-
ing to the current device set-
tings.
Indications which are read
by Modbus slave devices
are available in the list box if
they were parameterized in
Modbus Master Mapping.
-none- -none-
Device OK
Battery Failure
Settings Load
Settings Check
Settings Activate
Modbus TCP OK
Ethernet Link Error
Time Synchronization Error
Primary NTP Server Error
Secondary NTP Server Error
Daylight Saving Time
Ethernet Link 2 Error
Default IP Address
Limit Violation x (x = 1 to 16)
*)
Indication 1 from Remote
Indication 2 from Remote
Rotation Voltage Clockwise
Group Indication x (x = 1 to 4)
*)
IEC 61850 Communication OK
SD Card Error
Voltage Event Available
Frequency Event Available
Voltage-Unbalance Event Available
Indication x from Remote (x = 3 to 14)
SICAM Subdevice 1 OK
SICAM Subdevice 2 OK
Binary Input x-N SICAM IO 1 (x = 1 to 3)
*)
Binary Input x-P SICAM IO 1 (x = 1 to 3)
*)
Binary Input x-N SICAM IO 2 (x = 1 to 3)
*)
Binary Input x-P SICAM IO 2 (x = 1 to 3)
*)
Load profile period closed
Load profile synchr. period
Load profile tariff x (x = 1 to 6)
Binary input 1
*)
Binary input 2
*)
Modbus RTU Master OK
New MSV record made
Indication x Slv y (x = 1 to 6; y = 1 to 8)
*)
*)
Designation can be changed during the
parameterization.
Source inverted no no
yes
Logic operation NONE NONE
OR
AND
Group indication name Group Indication x
(x = 1 to 4)
Any
Max. 31 characters
1)
To Next Page
Loading...
