Siemens SICAM Q100 - Page 348

15 Operating Parameters
15.3 HMI
348 SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A4, Edition 03.2018
2 measured values, numerical
Display 1, numerical
Display 2, numerical
-none- -none-
Va, Vb, Vc
Vab, Vbc, Vca
Ia, Ib, Ic
VN, Vavg
IN, Iavg
Pa, Pb, Pc, P
Qa, Qb, Qc, Q
Sa, Sb, Sc, S
cos  (a), cos  (b), cos  (c), cos 
PFa, PFb, PFc, PF
UIa, UIb, UIc, UI
f
Neg.seq.comp.V
Neg.seq.comp.I
THDS Va, THDS Vb, THDS Vc
THDS Vab, THDS Vbc, THDS Vca
THDS Ia, THDS Ib, THDS Ic
ab V, bc V, ca V
ab I, bc I, ca I
Q1a, Q1b, Q1c, Q1
Pinst (a-n), Pinst (b-n), Pinst (c-n)
Pst (a-n), Pst (b-n), Pst (c-n)
Plt (a-n), Plt (b-n), Plt (c-n)
Pinst (a-b), Pinst (b-c), Pinst (c-a)
Pst (a-b), Pst (b-c), Pst (c-a)
Plt (a-b), Plt (b-c), Plt (c-a)
Zero seq.comp.V
Zero seq.comp.I
WPa_exp
WPb_exp
WPc_exp
WP_exp
WPa_imp
WPb_imp
WPc_imp
WP_imp
WQa_ind
WQb_ind
WQc_ind
WQ_ind
WQa_cap
WQb_cap
WQc_cap
WQ_cap
WSa
WSb
WSc
WS
MV x from Bus device y
*)
(x = 1 to 15 and y = 1 to 8)
(Setting ranges pending from network
type)
*)
Designation can be changed during the
parameterization.
4 measured values, numerical
Display 1, numerical
Display 2, numerical
Display 3, numerical
Display 4, numerical
-none-
2 measured values, graphical
and numerical
Display 1, graph./num.
Display 2, graph./num.
-none-
3 measured values, graphical
and numerical
Display 1, graph./num.
Display 2, graph./num.
Display 3, graph./num.
-none-