6 Getting Started
6.6 Meaning of the LEDs
98 SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A4, Edition 03.2018
6.6 Meaning of the LEDs
7KG95xx automatically monitors the functions of its hardware and software components. The LEDs on the top
side of the housing indicate the current device status.
Figure 6-4 Designation of the LEDs
Depending on the status, the LEDs can be permanently on, flashing, or off. The states are described in
chapter 12.3. The meaning of the LEDs during normal operation is explained in the following table:
RUN
H1
Link/Activity
ERROR
H2
Speed
NOTE
LEDs are also located on the display side; their designations are RUN, ERROR, H1, and H2 and their functions
are the same as the functions of the LEDs on the top of the housing.
Table 6-1 Meaning of the LEDs
LED Meaning
RUN Device active
ERROR Indicates an error according to parameterization
H1 According to parameterization
H2 According to parameterization
Link/Activity LED on: Ethernet link is up
LED flashing: Ethernet link is up and data are transferred
LED off: no Ethernet partners connected
Speed LED on: 100 Mbit/s
LED off: 10 Mbit/s
To Next Page
Loading...
