Siemens SICAM - Page 133

Phase Angle I
2
(Address 1012) This register contains the phase angle I
2
with reference to the voltage V1.
Refer to Phase Angle I
1
, Page 132.
Phase Angle I
3
(Address 1013) This register contains the phase angle I
3
with reference to the voltage V1.
Refer to Phase Angle I
1
, Page 132.
Phase Angle I
N
(Address 1014) This register contains the phase angle I
N
with reference to voltage V1.
Refer to Phase Angle I
1
, Page 132.
Phase Angle V
12
(Address 1015) This register contains the phase angle V
12
.
Refer to Phase Angle I
1
, Page 132.
Phase Angle V
23
(Address 1016) This register contains the phase angle V
23
.
Refer to Phase Angle I
1
, Page 132.
Phase Angle V
31
(Address 1017) This register contains the phase angle V
31
.
Refer to Phase Angle I
1
, Page 132.
Phase Angle V
1
(Address 1018) This register contains the phase angle V
1
. V1 is the reference voltage. Based on this angle, all
other phase angles are calculated. The value of V1 is always zero.
Refer to Phase Angle I
1
, Page 132.
Phase Angle V
2
(Address 1019) This register contains the phase angle V
2
with reference to the voltage V1.
Refer to Phase Angle I
1
, Page 132.
Phase Angle V
3
(Address 1020) This register contains the phase angle V
3
with reference to the voltage V1.
Refer to Phase Angle I
1
, Page 132.
Phase Angle V
NG
(Address 1021) This register contains the phase angle V
NG
with reference to the voltage V1.
Refer to Phase Angle I
1
, Page 132.
Apparent Power Phase 1
(Address 1022) This register contains the apparent power phase 1.
Modbus Registers
B.5 Register-Type Data – Input Registers
SICAM, Feeder Condition Monitor, Manual 133
E50417-H8940-C580-A4, Edition 03.2019