EasyManua.ls Logo

Siemens Simantic ET 200S - Page 213

Siemens Simantic ET 200S
274 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Analog electronic modules
4.16 2AI RTD High Feature analog electronic module (6ES7134-4NB51-0AB0)
ET 200S
Manual, Edition 10/2005, A5E00514527-01
4-83
Note
Please note the following to ensure optimum line compensation in the case of Cu10:
The sum of the cable resistance and measurement resistance must not exceed 31 Ω.
The cable must have a resistance of no more than 8 Ω if you want to use the
temperature range up to and above 312 °C.
Example: A 200 m Cu cable with a 0.5 mm
2
conductor cross-section has
approximately 7 Ω. A smaller cross-section shortens the permissible cable length
accordingly.
Using PTC resistors
PTCs are suitable for temperature monitoring and as thermal protective devices for complex
drives and transformer windings.
Select "Two-wire resistor" and "PTC" at parameter assignment:
Connect the PTC in accordance with the two-wire connection method.
Apply PTC resistors of type A (PTC thermistors) in accordance with DIN / VDE 0660,
Part 302.
Sensor data for the PTC resistor:
Features Technical
Specifications
Remarks
Behavior with rising temperature
< 550Ω Normal range:
SIMATIC S7: Bit 0 = "0", Bit 2 = "0" (in the PII)
SIMATIC S5: Bit 3 = "0", Bit 5 = "0" (in the PII)
550Ω to 1650Ω Prewarning range:
SIMATIC S7: Bit 0 = "0", Bit 2 = "1" (in the PII)
SIMATIC S5: Bit 3 = "0", Bit 5 = "1" (in the PII)
> 1650Ω Addressable range:
SIMATIC S7: Bit 0 = "1", Bit 2 = "0" (in the PII)
SIMATIC S5: Bit 3 = "1", Bit 5 = "0" (in the PII)
Behavior with rising temperature
> 750Ω Addressable range:
SIMATIC S7: Bit 0 = "1", Bit 2 = "0" (in the PII)
SIMATIC S5: Bit 3 = "1", Bit 5 = "0" (in the PII)
750Ω to 540Ω Prewarning range:
SIMATIC S7: Bit 0 = "0", Bit 2 = "1" (in the PII)
SIMATIC S5: Bit 3 = "0", Bit 5 = "1" (in the PII)
Switching points
< 540Ω Normal range:
SIMATIC S7: Bit 0 = "0", Bit 2 = "0" (in the PII)
SIMATIC S5: Bit 3 = "0", Bit 5 = "0" (in the PII)
(TNF-5) °C
(TNF+5) °C
(TNF+15) °C
Measuring voltage
Voltage on the PTC
max. 550 Ω
min. 1330 Ω
min. 4000 Ω
max. 7.5V
TNF= rated operating temperature

Table of Contents

Related product manuals