Digital input module DI 8x24VDC 4xM12 (6ES7141-5AF00-0BA0)
Manual, 02/2016, A5E36680963-AA
23
Pause function
Introduction
PROFIenergy is a PROFINET-based data interface for switching off consumers centrally and
in a coordinated manner during pause times regardless of the manufacturer or device type.
This has the aim that the process is only provided with the energy that is absolutely required.
The majority of the energy is saved by the process itself; the PROFINET device itself only
contributes a few watts of saving potential. In PROFIenergy, this operating state is referred
to as a "pause".
You enable and disable the pause function of the system at the beginning and end of
pauses, respectively; the IO controller then sends the PROFIenergy command "Start_Pause"
or "End_Pause" to the modules.
Use the "Start_Pause" command to start a pause.
Use the "End_Pause" command to end a pause.
The following conditions will also cause a pause to be ended:
● Reconfiguration in RUN
● Controller failure
● Firmware update
● Station stop
● Restart of the interface module through:
– POWER OFF/POWER ON of an interface module
– POWER OFF/POWER ON of an I/O module
– Termination of ET-Connection1 or ET-Connection2
The specific behavior of the digital input module is explained in the following section.
You can find additional information on working with PROFIenergy in the "PROFIenergy"
section of the manual IM 157-1 PN interface module
(https://support.industry.siemens.com/cs/ww/en/view/89254863) and the "Saving energy with
PROFIenergy" section of function manual PROFINET with STEP 7 V13
(https://support.industry.siemens.com/cs/ww/en/view/49948856).
Application examples (https://support.industry.siemens.com/cs/ww/en/view/41986454) are
also available on the Internet.
To Next Page
Loading...
