Siemens SIMATIC ET 200SP CM 1xDALI - DALI bus topology

ET 200SP CM 1xDALI Communication Model Description
18 Programming Manual, 12/2019, A5E47581955-AA
CM 1xDALI command list
3
Through the following commands, the CPUs can communicate with CM 1xDALI. Refer to
chapter
5.1 CM 1xDALI data storage model in the manual of ET 200SP Communication
module CM 1xDALI (https://support.industry.siemens.com/cs/ww/en/view/109769428)
to
understand the storage model of CM 1xDALI.
You can send every command over a data record. The marked commands can be sent
alternatively over process image.
Category
Command ID
Command Name
Over process im-
age
System 0 Poll the status and event of CM
1xDAL (Page 20)I
√
61
Send DALI command (Page 21)
√
62
Reset module status (Page 22)
√
Dimming Control
1
Query level (Page 22)
√
2
Set level (Page 23)
√
3
Query control gear color (Page 23)
√
4
Set control gear color (Page 24)
√
5 Go to control gear scene (Page 25) √
6~10
Reserved
Diagnostic 11 Query control gear status (Page 25) √
12
Check control gear status (Page 26)
13 Query control gear operating hours
(Page 29)
√
14 Set control gear operating hours
(Page 29)
√
15
Query input device status (Page 30)
16
Check input device status (Page 31)
17 Query instance input value of input
device (Page 31)
√
18
Query device GTIN (Page 32)
√
19~20
Reserved
Configuration
21
Add control gear (Page 32)
√
22
Remove control gear (Page 33)
√
23 Query control gear basic parameters
(Page 34)
24 Set control gear basic parameters
(Page 35)
25 Query control gear extended pa-
rameters (Page 35)
26 Set control gear extended parame-
ters (Page 37)