Siemens SIMATIC ET 200SP CM 1xDALI - Parameters; Parameter assignment; CM 1 xDALI Module Parameters

CM 1xDALI command list
3.2 Control gear dimming
ET 200SP CM 1xDALI Communication Model Description
22 Programming Manual, 12/2019, A5E47581955-AA
3.1.3 Reset module status
Description
Use this CM command to reset the status of the CM 1xDALI module. It stops the
quiescent mode, go to active mode (clear the bit 1 and bit 2 of status in Poll the
status and event of CM 1xDALI (Page 20)).
Command ID
61
Input Parame-
ters
None
Response
Parameters
Byte 0 Return code (Page 51)
Comment
As this command has no input parameters, the length of input parameters is 0.
3.2 Control gear dimming
Use control gear dimming commands to query or set the level and color of the control gears.
3.2.1 Query level
Description
Use this CM command to query the actual arc power level of a control gear.
Command ID
1
Input Param-
eters
Byte 0 Short address of the control gear
Response
Parameters
Byte 0
Return code (Page 51)
Byte 1
Actual level